Version 3.0 of the pump selector program is available immediately for downloading.

The following procedure should be adopted to update your version:

1. Start the PumpSelector.


2. Press the button “Data update via Internet” in your program.


3. A later version is found and displayed in a dialogue window.


4. Select the desired update – normally only one is available – otherwise mark them one after the other from the top down and install.


5. After downloading the data, an inquiry is made: "Should the updated data now be imported?"
   - Click on "Yes". This concludes the updating.

• The electronic type comparison for all wet rotor/circulating pumps now forms part of the software.



• Various optimizing and conditioning work has been performed.